[linux-dvb] Re: Need help getting firmware to load

[bob <bobself@charter.net>]

Tim Kaiser wrote:

> Hi Bob!
> -Download the firmware from the server.
> -Rename the file to " dvb-ttpci-01.fw"
> -Copy the file to the location described in qconf
>
> Alternativ you can compile the firmware direct into the kernel.
> But the steps above are the same
>
> Good luck
>
> Tim
>
> Am Donnerstag, 28. Oktober 2004 14:27 schrieb bob:
>  
> > Running gentoo 2.6.9 with dvb-ttpci compiled into the kernel. When the
> > system boots I get the error message
> >
> > saa7146: register extension 'dvb'.
> > ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI 11 (level, low) -> IRQ 11
> > saa7146: found saa7146 @ mem d0810e00 (revision 1, irq 11) (0x13c2,0x0003).
> > dvb-ttpci: cannot request firmware!
> > file not found: dvb-ttpci-01.fw
> >
> > I've checked everything I can think of. Can someone help?
> >
> > the complete diary of what I've tried to get this running is at
> > www.toadhaul.org/linux.php It includes a link to my current
> > /usr/src/linux/.config file at the bottom
> >
> > thanks,
> > bob
> >    
>
>
>  
I already copied 
http://www.linuxtv.org/download/dvb/firmware/dvb-ttpci-01.fw-261c
to dvb-ttpci-01.fw /usr/lib/hotplug/firmware/dvb-ttpci-01.fw

I also have already compiled the driver into the kernel. Here is my 
.config file:
http://www.toadhaul.org/_config-2.6.9-1

I've checked the hotplug stuff that I know about.

fstab:  http://www.toadhaul.org/fstab.gentoo
dmesg output:   http://www.toadhaul.org/dmesg.txt

thanks again,
bob