[linux-dvb] Re: ATSC Parameters

[Manu Abraham <manu@kromtek.com>]

On Thu December 9 2004 10:36 am, Luke Jenkins wrote:
> AVR Freaks has a Design Note written by Thomas Dais that might be the
> solution for you:
>
> http://www.avrfreaks.net/Tools/ToolFiles/411/DN_048.pdf
>
> It monitors the clock and data lines and dumps the data to a serial port.
>
> It is only a few chips and could be built on perf board. The only
> challenge you might have is programing the chip.
The problem would be the AVR programmer..

Manu
>
> Luke
>
> On Wed,  8 Dec 2004 15:19:55 -0500, Taylor Jacob <rtjacob@earthlink.net> 
wrote:
> > > I will check my collection... Give me some time.. I will check it on
> > > Friday, since office is closed.
> > >
> > > In the end where i drew a line was some chipsets do leave the ports in
> > > a different state.. eventhough the so called initialization.
> > >
> > > This was during my experiments with the Microchip PIC 16F84 micro's and
> > > the Parallel port.
> >
> > I had considered just using a PIC with USB or Serial and i2c on it and
> > making a logger out of it, but realized it would add one more project
> > that would keep me from the real task.. I will be curious what you dig up
> > though..
> >
> > Taylor