[vdr] Problem with svdrp

[Jochen Knuth <jok2@gmx.net>]

Hi,

i try to use vdr with svdrp.

i did the setup with the drivers siemens_dvb-0.9.4-2002-06-23 and vdr-1.0.4 on 
a Gentoo Linux 1.2 system with kernel 2.4.19. The Card is a DVB-C v1.3 from 
Siemens.
I can compile the drivers and load them. vdr is compiled with REMOTE=NONE.
I get these entries in the log files if i start vdr with "vdr -d":
----------------------
Sep  3 05:05:59 jokp4 vdr[5819]: VDR version 1.0.4 started
Sep  3 05:05:59 jokp4 vdr[5819]: loading /video/setup.conf
Sep  3 05:05:59 jokp4 vdr[5819]: loading /video/channels.conf
Sep  3 05:05:59 jokp4 vdr[5819]: loading /video/svdrphosts.conf
Sep  3 05:05:59 jokp4 vdr[5819]: loading /video/ca.conf
Sep  3 05:05:59 jokp4 vdr[5819]: probing /dev/ost/frontend0
Sep  3 05:05:59 jokp4 vdr[5819]: ERROR (dvbapi.c,2305): Operation not 
permitted
Sep  3 05:05:59 jokp4 vdr[5821]: EIT processing thread started (pid=5821) - 
master
Sep  3 05:05:59 jokp4 vdr[5819]: probing /dev/ost/frontend1
Sep  3 05:05:59 jokp4 vdr[5819]: found 1 video device
Sep  3 05:05:59 jokp4 vdr[5819]: setting primary DVB to 1
Sep  3 05:05:59 jokp4 vdr[5819]: reading EPG data from /video/epg.data
Sep  3 05:05:59 jokp4 vdr[5819]: switching to channel 2
Sep  3 05:05:59 jokp4 vdr[5819]: SVDRP listening on port 2001
-------------------------

if i then try to telnet to localhost port 2001 i get
Trying 127.0.0.1...
telnet: Unable to connect to remote host: Connection refused

My svdrphosts.conf is in /video and contains:
---------------------
#
# svdrphosts    This file describes a number of host addresses that
#               are allowed to connect to the SVDRP port of the Video
#               Disk Recorder (VDR) running on this system.
# Syntax:
#
# IP-Address[/Netmask]
#

127.0.0.1             # always accept localhost
#192.168.100.0/24     # any host on the local net
#204.152.189.113      # a specific host
172.16.0.0/16         # my network
0.0.0.0/0            # any host on any net (USE THIS WITH CARE!)
172.16.4.4
---------------------------

A try with vdr version 1.1.8 shows the same behaviour, only the ERROR message 
is different 
ERROR (dvbdevice.c,297): Operation not permitted

Any hints what is wrong?

Ciao,
Jochen