[vdr] Re: VDR developer version 1.1.9

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Meinrad Sauter wrote:
> 
> Hi Klaus, hi all,
> 
> great feature, and it works...
> ...at least for a few seconds. Then I get
> GPIO0 irq oops
> ...
> many of them and then:
> dvb0: arm crashed
> 
> This happens both when trying to timeshift and switching channels when a
> recording is running.
> 
> Any Idea?
> BTW: Tried the CVS driver with FW from NEWSTRUCT as well as your patched one.
> DVB is a TT v1.5

For a while I ran my VDR box with kernel 2.4.18 because of problems with
my MPEG encoder card. However, with that kernel apparently my harddisk
didn't work with DMA, so the performance was pretty bad. During that time
I also saw lots of "GPIO0 irq oops". Now I'm back to kernel 2.4.10 and it
works fine again.

I did see an ARM crash, though, today when I ran a recording and tried to
switch to a channel that was currently not available because the tranponder
was locked due to the recording. Haven't further inverstigated that yet...

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________