[vdr] Re: RGB Out on DVB-S 1.3

["Rene Bartsch" <vdr@bartschnet.de>]

----- Original Message -----
From: "Jean-Claude Repetto" <jrepetto@francenet.fr>
To: <vdr@linuxtv.org>
Sent: Monday, September 16, 2002 2:27 PM
Subject: [vdr] Re: RGB Out on DVB-S 1.3


>
> ----- Original Message -----
> From: "Rene Bartsch" <vdr@bartschnet.de>
> To: <vdr@linuxtv.org>
> Sent: Monday, September 16, 2002 12:28 PM
> Subject: [vdr] Re: RGB Out on DVB-S 1.3
>
>
> >
> > ----- Original Message -----
> > From: "Bernhard Ritter" <bernhard.ritter@digital-hobby.de>
> > To: <vdr@linuxtv.org>
> > Sent: Sunday, September 15, 2002 11:16 PM
> > Subject: [vdr] RGB Out on DVB-S 1.3
> >
> >
> > > Hi
> > >
> > > Hopefully somebody can help. I made a RGB cable like this :
> > > http://www2.arnes.si/~mthale1/rgb.html
> > > Unfortunately the picture is not synced. I can see all
colorinformatin,
> > > but the TV Sets does not sync the picture to get a sharp image. Does
> > > anybody know this problem ? Any solutions ? Or is this plan all well
and
> > > my TV is not functioning properly ?
> > >
> >
> > You can try to change the value of the 47 Ohm Resistor. Some TVs need
100
> > Ohm.
> > So try something between 47 and 150 Ohm ...
> >
> > Rene
> >
>
> The nominal value for the blanking signal is 1 volt on a 50-ohm impedance,
> so the resistor should be around 200 ohms if you connect it to +5 volts.
>
> Have you tried to send a 12 V voltage on pin 8 of the SCART-plug ? I think
> this should solve the "picture not synced" problem.
>


Pin8 also handles 5V, as 12V are specified for 4:3 and 5V for 16:9.
I connected pin2 (5V) of J2 with pin8 of SCART and switched the TV to 4:3
manually.

Rene