[vdr] Re: 1.1.13 - simple diseqc question

["Rene Bartsch" <vdr@bartschnet.de>]

----- Original Message -----
From: "Dariush Forouher" <dariush@forouher.de>
To: <vdr@linuxtv.org>
Sent: Sunday, October 27, 2002 2:19 PM
Subject: [vdr] Re: 1.1.13 - simple diseqc question


> Am Son, 2002-10-27 um 13.21 schrieb Rene Bartsch:
> > > That doesn't work with my switch. This is the easiest working config
> > > I've fount:
> > > S19.2E  11700 V  9750 t v # 1st LNB
> > > S19.2E  99999 V 10600 T v
> > > S19.2E  11700 H  9750 t V
> > > S19.2E  99999 H 10600 T V
> > > S13E    11700 V  9750 t v [E0 10 38 F4] t #2nd LNB
> > > S13E    99999 V 10600 t v [E0 10 38 F4] T
> > > S13E    11700 H  9750 t V [E0 10 38 F4] t
> > > S13E    99999 H 10600 t V [E0 10 38 F4] T
> > >
> > > In the "manual" of the switch is written, that it only supports diseqc
> > > 1.0. Could this be the reason?
> > >
> >
> > No, the above Hex-commands are diseqc 1.0.
> > You're only using 22khz/13V/18V at ASTRA to switch (very slow ...)
> >
> > I assume you're running a 9/x-multiswitch with two quaddro-LNBs, first
> > directed to ASTRA and the second to HOTBIRD?
> No, I'm using two Switchable-LNBs(Astra&Hotbird on multifeed) connected
> to a "2 in, 1 out" switch. (Axina spu 21-02 by reichelt).
> I would really prefer a faster solution, but using diseqc commands only
> doesn't seem to work with this device.
>

You just enlighten the world ;o)

The switching-commands have to be set in a way they can switch the SAT
SPU21-02.
On the Reichelt-page I only could see it supports diseqc 2.0.

What does the manual say about diseqc 1.0 and 22kHz/13V/18V?
Does it pass-through diseqc 1.0 and 22kHz/13V/18V to the LNB?

Rene



-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.