Mailing List archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[vdr] Re: lirc with zapway receiver
If its any help I got a cheap(ish) IR receiver for VDR from ebay:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=2745940413
This works great with lircd via the irdeo driver.
-----Original Message-----
From: vdr-bounce@linuxtv.org [mailto:vdr-bounce@linuxtv.org] On Behalf
Of Matthias Bodenbinder
Sent: 05 September 2003 18:56
To: vdr@linuxtv.org
Subject: [vdr] lirc with zapway receiver
Hi,
I know that this is probably off-topic, but I do not have signed on for
a
whole lot of mailling lists.
I have trouble getting my zapway IR receiver (www.zapway.de) working
with
lirc-0.6.6 (self-compile on SuSE 8.2 with vdr-1.2.2).
With lirc I did:
./configure --with-driver=serial
make
make install
then (according to
http://www.linux-user.de/ausgabe/2001/12/060-vdr-2/vdr-2.html)
setserial /dev/ttyS0 uart none
modprobe lirc_serial
/var/log/messages says:
lirc_serial: auto-detected active high receiver
which is correct.
But when I start irrecord as user root it says:
43# irrecord -f /etc/lircd.conf
irrecord - application for recording IR-codes for usage with
lirc
Copyright (C) 1998,1999 Christoph Bartelmus(lirc@bartelmus.de)
irrecord: could not get hardware features
irrecord: this device driver does not support the new LIRC
interface
irrecord: make sure you use a current version of the driver
irrecord: could not init hardware (lircd running ? --> close it,
check
permissions)
lircd is not running. Where is the problem? Please help me out.
Matthias
--
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr"
as subject.
--
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.
Home |
Main Index |
Thread Index