[vdr] Re: vdr and motorised dish

[Tomas Prybil <vdrmail@prybil.se>]

mc8647 wrote:
> Tomas Prybil ha scritto:
>
> > I have a HH100, how would an actual diseqc.conf look like?
>
> You have 2 possibilities, one now and one in the next future (a week or 
> two):
>
> 1) Use actual rotor-plugin (v. 4): you can move the dish East/West, 
> store the position, go to a position. In diseqc.conf  you will find 
> commands like: E0 31 6B XX, where 6B is the Goto To Position command and 
> XX is the stored position. Internally, positions are stored as steps of 
> the step-by-step motor inside the rotor from the 0.
> The procedure is long and tedious !
OK,
Thomas Bergwinkl pointed out the fact that I needed to tell the plugin 
to use card no1 instead of the "default" no2.
After that I manage to actually move the antenna back and forth and to 
tune into different transponders. That really works good!

Now I would like to store the positions and be able to recall them.
My example would be to store a new position #3 for Thor at S1W. My 
diseqc.conf would then need to add:

S1W 11700 V 9750 t v W15 [E0 31 6B 03] W1 [E0 31 6B 03] W1 [E0 31 6B 03] 
W15 t
S1W 99999 V 10600 t v W15 [E0 31 6B 03] W1 [E0 31 6B 03] W1 [E0 31 6B 
03] W15 T
S1W 11700 H 9750 t V W15 [E0 31 6B 03] W1 [E0 31 6B 03] W1 [E0 31 6B 03] 
W15 t
S1W 99999 H 10600 t V W15 [E0 31 6B 03] W1 [E0 31 6B 03] W1 [E0 31 6B 
03] W15 T

to be able to recall Thor, right?

The problem is when I try to tune or change into one of the channels 
which corresponds to S1W the dish moves elsewhere.....

/t


--
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.