Hi All,
I use an USB DVB-T receiver. This works ok, but the snr meter at the bottom of the screen is never filled more than a few pixels, no matter how good the signal is. The problem with this receiver is that the snr figure never goes above 0x00d0. Is there a way to adjust the scaling of the signal and snr bars? I would like the snr bar to be fully filled when the figure is 0x00ff
Best regards, Cedric
$ lsusb Bus 001 Device 004: ID 2013:0245 PCTV Systems PCTV 73ESE
$ tzap -a 0 -r 'Nederland 1' using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' reading channels from file '/home/cedric/.tzap/channels.conf' tuning to 474000000 Hz video pid 0x1b63, audio pid 0x1b64 status 1b | signal 0dbd | snr 00a2 | ber 001fffff | unc 00000000 | FE_HAS_LOCK
$ dmesg [ 3.519233] dvb-usb: found a 'Pinnacle PCTV 73e SE' in cold state, will try to load a firmware [ 3.529962] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-1.20.fw' [ 3.871202] dib0700: firmware started successfully. [ 4.373456] dvb-usb: found a 'Pinnacle PCTV 73e SE' in warm state. [ 4.373567] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. [ 4.373732] DVB: registering new adapter (Pinnacle PCTV 73e SE) [ 4.568680] DVB: registering adapter 0 frontend 0 (DiBcom 7000PC)... [ 4.766795] DiB0070: successfully identified [ 4.830021] Registered IR keymap rc-dib0700-rc5 [ 4.831325] input: IR-receiver inside an USB DVB receiver as /devices/pci0000:00/0000:00:10.4/usb1/1-6/rc/rc0/input6 [ 4.831485] rc0: IR-receiver inside an USB DVB receiver as /devices/pci0000:00/0000:00:10.4/usb1/1-6/rc/rc0 [ 4.831681] dvb-usb: schedule remote query interval to 50 msecs. [ 4.831688] dvb-usb: Pinnacle PCTV 73e SE successfully initialized and connected.