AVerMedia AVerTV DVB-S Hybrid+FM (A700)
Jump to navigation
Jump to search
A hybrid DVB-S PCI card from AVerMedia.
It is currently unsupported under Linux, however, experimental drivers exist (see below for details).
Note: A non-hybrid version of the card also exists; see AVerTV DVB-S Pro (A700)
Overview/Features
- DVB-S input; svideo, composite input; analog RF input; IR input
Components Used
- Xceive XC2028 (Analog Tuner) (i2c-addr: unknown)
- Zarlink ZL10036 (DVB-S Tuner) (i2c-addr: 0x60)
- Zarlink ZL10313 (DVB-S Demodulator) (i2c-addr: 0x0e)
- Philips SAA7135HL (PCI Bridge)
- 24CC02 (Serial EEPROM 2KBit) (i2c-addr: 0x50)
Identification
The output of lspci -vvnn reveals:
02:07.0 Multimedia controller [0480]: Philips Semiconductors SAA7133/SAA7135 Video Broadcast Decoder [1131:7133] (rev d1)
Subsystem: Avermedia Technologies Inc Unknown device [1461:a7a2]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 64 (63750ns min, 63750ns max)
Interrupt: pin A Route to IRQ 18
Region 0: Memory at d3024000 (32-bit, non-prefetchable) [size=2K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=3 PME-
Making it Work
Firmware
Drivers
Sample kernel output
After passing the command modprobe saa7134 i2c_scan=1, the relevant output of from dmesg is as follows:
saa7133[0]: found at 0000:02:07.0, rev: 209, irq: 18, latency: 64, mmio: 0xd3024000 saa7133[0]: subsystem: 1461:a7a2, board: UNKNOWN/GENERIC [card=0,autodetected] saa7133[0]: board init: gpio is 6da00 saa7133[0]: i2c eeprom 00: 61 14 a2 a7 ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom e0: 00 01 81 af d7 09 ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c scan: found device @ 0x1c [???] saa7133[0]: i2c scan: found device @ 0xa0 [eeprom] saa7133[0]: registered device video0 [v4l2] saa7133[0]: registered device vbi0