LinuxTV:Help desk

Welcome

new and old LinuxTV wikians. You have questions how to help with LinuxTV Wiki? Question about the articles or there meaning? Then this is the right place to ask. Ask your question, others will answer.

Please follow the following guidelines

• Put new questions at the end.
• Please give every question a headline (==Title of the question==).
• If the question refers to a certain article a [[link]] there would be helpful.
• Please sign with --~~~~.

---

How can I use ATSC DTV receiver on PowerPC?

I test below enviroment on PS3

* OS : Yellow Dog Linux 5.0
* receiver : DIVICO FusionHDTV gold usb
 - This receiver doing well on X86 linux(fedora 5 core)    

Question :

* What Kernel configuration need on or can I get kernel config file that succeeded on PS3?
* is Kernel hacking needed?
* Can I get firmware file for receiver or device driver?
  If I can get it, please let me know where it is.

Cannot upload images

I tried to upload pictures I took of my Twinhan VP-1030C but it failed with the following error:

Internal error
From LinuxTVWiki
Could not copy file "/tmp/phpASqZa6" to "/var/www/wiki/images/temp/4/46/20050310231202!Twinhan_VP-1030C_Front.jpg".

---

Twinhan / Brooktree 1020a with Debian Sid and Kernel 2.6.14

I tried to install my DVB-S card on Linux: I set up my kernel with the needed modules and restart, but the kernel hangs up
if the card was recognized.

Output of lspci -v (only bt878 relevant devices)

0000:01:0a.0 Multimedia video controller: Brooktree Corporation Bt878 Video Capture (rev 11)
        Subsystem: Unknown device fefe:0001
        Flags: bus master, medium devsel, latency 64, IRQ 5
        Memory at cfffe000 (32-bit, prefetchable) [size=4K]
        Capabilities: <available only to root>

0000:01:0a.1 Multimedia controller: Brooktree Corporation Bt878 Audio Capture (rev 11)
        Subsystem: Unknown device fefe:0001
        Flags: bus master, medium devsel, latency 64, IRQ 5
        Memory at cffff000 (32-bit, prefetchable) [size=4K]
        Capabilities: <available only to root>

Which settings I need for this card? (maybe any service is the actuator for the kernel hangup)