Quadrature amplitude modulation: Difference between revisions
No edit summary |
No edit summary |
||
| Line 9: | Line 9: | ||
Quadrature Amplitude Modulation is usually used for [[DVB-C]] and [[DVB-T]], typically QAM-16, QAM-64 or (in finnish cable networks) QAM-128 are used. |
Quadrature Amplitude Modulation is usually used for [[DVB-C]] and [[DVB-T]], typically QAM-16, QAM-64 or (in finnish cable networks) QAM-128 are used. |
||
U.S. networks also use [[8VSB]] Modulation then and when. |
U.S. networks also seem to use [[8VSB]] Modulation then and when. |
||
Revision as of 22:55, 28 September 2004
A Modulation Scheme where both Phase and Amplitude are used to encode a symbol. The attached number specifies how many different states can get encoded, e.g. QAM-64 encodes 64 States in the Phase Diagram, QAM-256 encodes 256 States.
The following pictures give you an idea what happens.
|
|
The more states are encoded for a given allowed signal Bandwidth the more susceptible the signal is to noise. On the other hand, the more states are possible the more bandwith is in theory possible. But only if the signal quality is good enough to decide between the different states because amplitude noise and phase noise will disturb the signal.
Quadrature Amplitude Modulation is usually used for DVB-C and DVB-T, typically QAM-16, QAM-64 or (in finnish cable networks) QAM-128 are used.
U.S. networks also seem to use 8VSB Modulation then and when.