KNC One TV-Station DVR
Card features
- PCI interface
- SAA7134 chipset
- RDS-Tuner Chip SAA6588 chopset
- MPEG-Decoder Chip SAA6752HS
- FM, TV, Composite, S-Video and Audio inputs (outside)
- Two conectors (one is Audio out) (inside)
How to make it work
It was detected automaticly as card=24.
The sound dosn't work from internal Mixer (in the moment - should work according to Video4Linux Mailing List). I solve it in the moment, that I use the Audio-out conector inside. If you hold the slot-metall at left and the PCI-conector on the lower side, the Audio-Out conector is on the lower one. The 4 pins from the white MIDI-conector are from left side: left-chanel / ground / right-chanel / ground. This one I conect with one Audio-Input (Aux) on my sound card (SoundBlaster Live! 5.1). If I switch the input to this chanel, the sound works fine.
The MPEG-Decoder dosn't work (in the moment - should work according to Video4Linux Mailing List).
Kernel
The card runs on Kernel 2.6.11.4 (SuSE 9.3).
Not all features suported in the moment. Working in process.
Cuting from my message-log:
saa7130/34: v4l2 driver version 0.2.12 loaded ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI 19 (level, low) -> IRQ 209 saa7134[0]: found at 0000:00:0a.0, rev: 1, irq: 209, latency: 64, mmio: 0xf6000000 saa7134[0]: subsystem: 1894:a006, board: KNC One TV-Station DVR [card=24,autodetected] saa7134[0]: board init: gpio is 830000 saa7134[0]: i2c eeprom 00: 94 18 06 a0 06 80 00 01 00 00 00 00 00 00 01 00 saa7134[0]: i2c eeprom 10: 00 ff 86 0e ff 20 ff ff ff ff ff ff ff ff ff ff saa7134[0]: i2c eeprom 20: 01 40 01 02 02 03 01 03 06 ff 01 df ff ff ff ff saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff tuner: chip found at addr 0xc0 i2c-bus saa7134[0] tuner: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) by saa7134[0] tda9885/6/7: chip found @ 0x86 saa6752hs: chip found @ 0x40 saa7134[0]: registered device video0 [v4l2] saa7134[0]: registered device vbi0 saa7134[0]: registered device radio0 saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default] saa7134[0]/irq[10,4294915314]: r=0x20 s=0x00 PE saa7134[0]/irq: looping -- clearing PE (parity error!) enable bit
Module parameters
Viewers
kRadio (dosn't work in the moment - see above)
Teletext
See also
bttv (and more) tv,video and radio card gallery
Linux runing Hardware chapter PCI-Karten (German)