Zolid Hybrid TV Tuner
NOTE: THE IMAGES ARE NOT UPDATED!
A Hybrid TV Tuner from Zolid.
The Hybrid TV Tuner is not supported by Linux.
Overview/Features
- Built-in IR transmitter
- PCI interface
- Hybrid tuner, both DVB and Analog TV are supported
Components Used
- NXP TDA18271 (tuner)
- NXP TDA10048 (demodulator)
- NXP/Philips SAA7131 (A/V decoder and PCI Interface)
Other Images
Identification
lspci -vvvnnxxx
04:09.0 Multimedia controller [0480]: Philips Semiconductors SAA7131/SAA7133/SAA7135 Video Broadcast Decoder [1131:7133] (rev d1) Subsystem: Philips Semiconductors Device [1131:2004] Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 32 (21000ns min, 8000ns max) Interrupt: pin A routed to IRQ 17 Region 0: Memory at fdcfe000 (32-bit, non-prefetchable) [size=2K] Capabilities: [40] Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=1 PME- Kernel driver in use: saa7134 Kernel modules: saa7134 00: 31 11 33 71 06 00 90 02 d1 00 80 04 00 20 00 00 10: 00 e0 cf fd 00 00 00 00 00 00 00 00 00 00 00 00 20: 00 00 00 00 00 00 00 00 00 00 00 00 31 11 04 20 30: 00 00 00 00 40 00 00 00 00 00 00 00 ff 01 54 20 40: 01 00 02 06 00 20 00 1c 00 00 00 00 00 00 00 00 50: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 60: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 70: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 80: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 e0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 f0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Making it Work
It is not supported by Linux. The subsystem has two matches, both reference boards: Philips TOUGH DVB-T reference design and Philips EUROPA V3 reference design. This can be found in CARDLIST.saa7134.
When loading the saa7134 module with the card parameter 156 (Hauppauge WinTV-HVR1110r3 DVB-T/Hybrid) with firmware installed (see below), the card seems to work, but fails when scanning DVB channels.
Firmware
The card needs firmware for the TDA10048.
Drivers
The card uses the built-in V4L saa7134 driver.
Sample Kernel Output
dmesg
2009-05-31 20:42:51 sander-desktop kernel [ 4169.257239] saa7134 ALSA driver for DMA sound unloaded 2009-05-31 20:42:59 sander-desktop kernel [ 4177.629232] saa7130/34: v4l2 driver version 0.2.15 loaded 2009-05-31 20:42:59 sander-desktop kernel [ 4177.629291] saa7133[0]: found at 0000:04:09.0, rev: 209, irq: 17, latency: 32, mmio: 0xfdcfe000 2009-05-31 20:42:59 sander-desktop kernel [ 4177.629297] saa7133[0]: subsystem: 1131:2004, board: UNKNOWN/GENERIC [card=0,autodetected] 2009-05-31 20:42:59 sander-desktop kernel [ 4177.629548] saa7133[0]: board init: gpio is 4400100 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792034] saa7133[0]: i2c eeprom 00: 31 11 04 20 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792044] saa7133[0]: i2c eeprom 10: 00 ff 86 0f ff 20 ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792051] saa7133[0]: i2c eeprom 20: 01 40 01 02 03 01 01 03 08 ff 00 b2 ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792057] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792064] saa7133[0]: i2c eeprom 40: ff 35 00 c0 96 10 03 32 21 05 ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792070] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792076] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792083] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792089] saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792095] saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792102] saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792108] saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792114] saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792120] saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792127] saa7133[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792133] saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792610] saa7133[0]: registered device video0 [v4l2] 2009-05-31 20:42:59 sander-desktop kernel [ 4177.792631] saa7133[0]: registered device vbi0 2009-05-31 20:42:59 sander-desktop kernel [ 4177.800153] saa7134 ALSA driver for DMA sound loaded 2009-05-31 20:42:59 sander-desktop kernel [ 4177.800183] saa7133[0]/alsa: saa7133[0] at 0xfdcfe000 irq 17 registered as card -2
Remote Control Support
The default card configuration doesn't detected the built-in IR transmitter.
External Links
The vender Zolid doesn't have a website, so there isn't much information available about this card.