WinTV-Radio

WinTV 44914 Rev C121

WinTV 44914 Rev C121 - Connectors

WinTV 44914 Rev C121 - Remote

WinTV Model 44914 Rev C121

An analog PCI card from Hauppauge.

Connectors

Radio In, TV In, Line Out, Composite In, Line In, IR In.

Support

Everything is working "out of the box" except bundled remote control.

It may be necessary to load bttv module with parameter automute=0 if audio is unwantedly muting.

Sample dmesg output

bttv: driver version 0.9.18 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv0: Bt878 (rev 17) at 0000:00:0a.0, irq: 18, latency: 32, mmio: 0xdfdfe000
bttv0: detected: Hauppauge WinTV [card=10], PCI subsystem ID is 0070:13eb
bttv0: using: Hauppauge (bt878) [card=10,autodetected]
IRQ 18/bttv0: IRQF_DISABLED is not guaranteed on shared IRQs
bttv0: gpio: en=00000000, out=00000000 in=00ffffdb [init]
bttv0: Hauppauge/Voodoo msp34xx: reset line init [5]
tveeprom 1-0050: Hauppauge model 44914, rev C121, serial# 3959906
tveeprom 1-0050: tuner model is Philips FM1216 (idx 21, type 5)
tveeprom 1-0050: TV standards PAL(B/G) (eeprom 0x04)
tveeprom 1-0050: audio processor is None (idx 0)
tveeprom 1-0050: has radio
bttv0: Hauppauge eeprom indicates model#44914
bttv0: tuner type=5
bttv0: audio absent, no audio device found!
tuner 1-0061: chip found @ 0xc2 (bt878 #0 [sw])
tuner-simple 1-0061: creating new instance
tuner-simple 1-0061: type set to 5 (Philips PAL_BG (FI1216 and compatibles))
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: registered device radio0
bttv0: PLL: 28636363 => 35468950 . ok