Universal Serial Bus

From LinuxTVWiki
Revision as of 08:23, 16 December 2016 by Voidxor (talk | contribs) (Spell integers less than 10. Use the notation "Mbit/s" since "Mbps" isn't used globally. Label bare link.)
Jump to navigation Jump to search

The Universal Serial Bus (USB) is a serial four-wire bus (ground, power, and a differential data signal transferred over two wires). A quite clever designed protocol for communication between the PC Host and peripheral devices like (e.g. DVB receivers). Since devices are defined as dumb clients that get polled by the USB Host Controller, USB device chipsets can be very cheap compared to IEEE1394 chips that provide essentially the same functionality.

Governed by the USB Consortium, USB specifications are openly available to the public at USB.org.

Many USB DVB devices are available from an wide assortment of different vendors.

USB 1.1

This older Universal Serial Bus variant specifies data transfer rates of 1.5 Mbit/s (Low-Speed devices) and 12 Mbit/s (Full-Speed devices).

USB DVB devices adhering to the USB 1.1 standard will operate at the Full-Speed specification. However, because Full-Speed devices are limited to a overall datarate (incl. Protocol overhead) of about 12 Mbit/s, this essentially prevents these devices from receiving HDTV steams and makes it impossible to receive some high-datarate services. Only High-Speed USB 2.0 DVB devices are able to transfer the full MPEG-2 Transport Stream or high-datarate Transponders.

USB 2.0

In terms of reception of digital TV (DTV) services, the 480 Mbit/s transfer rate of USB 2.0 overcomes several of the limitations of earlier USB 1.1 devices.

External Links

Retrieved from "https://www.linuxtv.org/wiki/index.php?title=Universal_Serial_Bus&oldid=35250"