[linux-dvb] Re: [vdr] Re: ERROR (dvbdevice.c,533)

[Oliver Endriss <o.endriss@gmx.de>]

Uwe Ortner wrote:
> Am Sam, 2003-05-03 um 23.24 schrieb Oliver Endriss:
> > Andreas Kool wrote:
> > > On Sat, May 03, 2003 at 08:28:10PM +0200, Uwe Ortner wrote:
> > > Could you please post a
> > >
> > >   lspci -nv | grep 0480 -A1
> > >
> > > here?
> >
> > Yesterday he posted this on the driver ml:
> > | 00:08.0 Class 0480: 1131:7146 (rev 01)
> > |         Subsystem: 110a:0000
> >
> > According to saa7146_core.c this is a full-featured
> > "Siemens cable card PCI rev1.5".
> >
> > | 00:09.0 Class 0480: 1131:7146 (rev 01)
> > |         Subsystem: 13c2:0002
> >
> > Is this a DVB-C card, too? According to saa7146_core.c this is a
> > full-featured "Technotrend/Hauppauge PCI rev2.1 or 2.2".
> >
> > > 00:0f.0 Class 0480: 1131:7146 (rev 01)
> > > 	Subsystem: 13c2:0000
> > > -------------------^^^^
> > > If you read the above, you have a Technotrend 1.3 card (like me)
> >
> > Ok, according to saa7146_core.c this is a full-featured
> > "Siemens/Technotrend/Hauppauge PCI rev1.3".
>
> there are 2 cards installed, Siemens + Hauppauge DVB-C

Of course. (For troubleshooting a single-card setup might be better...)

> > > In that case, you could simply use the DVB-cvs as of april, 29.
> > > 2003 (but not later!) ... works fine here!
> >
> > You can fix later drivers by adding your card id to the 'if'
> > statement at line 4965 (av7110.c). You can simply replace 0x1004,
> > which is wrong anyway (IMHO).
>
> I'will try this ...

IIRC, your problem is the Siemens DVB-C (110a:0000). Correct?
This card should be supported already, as the 0x110a id is included in 
that statement. Do you have an analog module?

Maybe there is a switch or jumper which has to be set if you don't have 
an analog module. (Sorry I don't have a DVB-C.)

Oliver


-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe linux-dvb" as subject.