On 09/12/2012 05:19, cedric.dewijs@telfort.nl wrote:
Hi All,
When I play a recording and pause it, then i see the screen is standing
still.
Then I press escape to exit vdr-sxfe. Then I start vdr-sxfe again. Now
i
see the "no signal" screen. I expected to see the screen standing still
at
the position I paused it.
I think it's the normal behavior. When xineliboutput is started, it doesn't have any data and if vdr doesn't send any because the stream is
paused, xineliboutput has nothing else to display than the no signal screen.
Marc.
I agree this behavior is normal and technically correct. I think its a bit confusing, because when I see no signal, i think there's something wrong with the receiving hardware, like crashed DVB-t receivers, loose antenna and so on.
Xineliboutput is aware the stream is paused. Therefore I can think of 2 solutions: 1)Display a screen that says "Paused" instead of "No signal" 2)Unpause, and then re-pause the stream, just long enough to let VDR send an image.
Best regards, Cedric