On Fri, 2009-06-05 at 23:40 +0300, Vesa wrote:
-----Original Message----- I have not seen those kinds issues with eHD card. But I use on my setup separate video processor (DVDO VP30 with abt102) for deinterlacing and scaling to 1080P.
Well, your setup is a little different than what I have.
I can get jagged lines when I use eHD own deinterlacer, it seems to miss even/odd field detection sometimes. Also TV:s own deinterlacer seems to lost half of resolution when video is 576i when comparing to DVDO.
Are you absolutely sure that signal is 576i on HDMI? What TV tells about video? It can be that also Mitsubishi sends 576P signal. True 576i/486i support is rare on HDMI devices, specification recommend always to use at least 576P, sd resolutions are possible but not recommended..
I am reasonably sure since it is a supported resolution in the VPR manual, and it is the listed resolution on the VPR on screen display.
At this point there can be three different explanations:
1 - the internal scaler of my VPR behaves differently when it receives 576i from the s-video port and the HDMI port
2 - I'm doing something wrong with the eHd output 3 - The ehd output - in my conditions - is really worse than the ff card
Will experiment further, and will let you know when/if I come to any conclusion
Thanks and regards
Mattia