Here is attached log for recording 17:43, after I tried to change back to the channel twice, it started recording, however if I left it, the file would have stayed zero.
On 08/02/2008, Theunis Potgieter theunis.potgieter@gmail.com wrote:
I am using vdr-1.5.13
- start vdr and switch to encrypted channel
- set timer on encrypted channel one minute in advance from current time
- switch to same Transponder with FTA channel, in my situation a radio channel
- once the timer started I cannot switch back to the encrypted channel
with message channel is not available. In the recordings list it shows the file but in 0 size.
- stop timer is the only way to switch back to encrypted channel.
Theunis
On 08/02/2008, Klaus Schmidinger Klaus.Schmidinger@cadsoft.de wrote:
I tried to reproduce this here, but everything worked fine. Here's what I did:
- start VDR with only a single FF card with one CAM
- switch to an encrypted channel
=> channel displays in live mode
- start a recording on that channel
=> recording successful
- switch to an FTA channel on the same transponder
=> channel displays in live mode
- start a recording on that channel
=> recording successful
At this point I had two recordings running on the same transponder, one with an encrypted channel and one FTA.
This also worked the other way round (first recording FTA, then encrypted).
This was done with the version 1.5.13 code base.
Does the problem still persist on your system with VDR 1.5.13?
Klaus
vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr