Re: [vdr] Help: Twinhan VP-1022a

Hi Robert,

could you give me some guide lines what you did to make this card work with vdr? We can communicate directly over email if you would prefer.

Andy

I'm using a Twinhan VisionPlus 1020 card. Unfortunately, this card seems to use the same device numbers than some analog cards do, and the driver Knoppix loads will hang the system.

I figured out that I have to load the bttv module with these options: i2c_hw=1 card=0x71

I have no idea on how to do this with Knoppix, but on Gentoo I created a file "/etc/modules.d/bttv" and put the following in it: options bttv i2c_hw=1 card=0x71 Then run modules-update.

On Fedora, you might want to try to modprobe bttv like this: modprobe bttv i2c_hw=1 card=0x71

Hope this helps, Robert