Hi all,
I've finally grabbed a second machine to setup by the TV and I want to run vdr in streamdev-client mode.
I have vdr running on my primary back-end machine.
I have an Xbox running vdr streamdev-client on Xebian and its working ok for the most part (vdr-1.3.27 I believe or it might be vdr-1.3.32). These came precompiled from a web site.
On this new slave machine, I've install Debian, vdr and xine. My problems are as follows:
1) The xine plugin never gets around to loading (you see the prompts on the output when its queuing frames -- I don't get that all the time). As a result, Xine starts and stops immediately.
2) When I did get it running (once or twice) you can't change channels without it going unresponsive. Remember, the backend runs perfectly with the same xine plugin so it's not a tuning issue.
3) Cosmetic but a pain -- when VDR exits, it always gives a segmentation fault.
Would I be better off to roll back to a previous version for this setup? If so, what version should I use?
I have a recent kernel, recent DVB drivers, the plugins are all recent as well.
Thanks Norm