Am 09.12.2012 10:14, schrieb cedric.dewijs@telfort.nl:
I agree this behavior is normal and technically correct. I think its a bit confusing, because when I see no signal, i think there's something wrong with the receiving hardware, like crashed DVB-t receivers, loose antenna and so on.
Xineliboutput is aware the stream is paused. Therefore I can think of 2 solutions: 1)Display a screen that says "Paused" instead of "No signal"
And how shall xineliboutput notice the difference?
2)Unpause, and then re-pause the stream, just long enough to let VDR send an image.
Xineliboutput didn't pause the stream, so it is not the job of xineliboutput to "unpause" the stream.
Gerald
!DSPAM:50c46e6f187481547110970!