To enable/disable GotoStoredPosition we would need a setting (on/off) on the Diseqc setup menu
If on, then in diseqc.conf commands like are sent to the rotor:
S19.2E 11700 V 9750 t W15 [E0 31 6B 01] W15 v t S19.2E 99999 V 10600 t W15 [E0 31 6B 01] W15 v T S19.2E 11700 H 9750 t W15 [E0 31 6B 01] W15 V t S19.2E 99999 H 10600 t W15 [E0 31 6B 01] W15 V T
(the syntax is E0 header, 31 first rotor, 6B = gotostored position
So If gotostoredposition is ON and the third byte of the diseqc 1.2 command is 6B then issue the command, otherwise block it
On 4/27/09, martinez@embl.de martinez@embl.de wrote:
To enable/disable GotoStoredPosition we would need a setting (on/off) on the Diseqc setup menu
<SNIP>
IMHO, VDR needs multi satellite support bundled with it (via diseqc 1.2), which could be achieved either in the core, or as a bundled plugin. The plugin should: -
1) Set East/West limits 2) Drive the rotor east/west for tuning 3) Store sat locations at certain position numbers 4) Display signal strength etc 5) Allow scanning of DVB-S / S2 transponders and add these to VDR channel lists
Mostly this is done by the rotor plugin, but it doesn't seem to be supported anymore. :-(
Thanks,
Morfsta
Hi, An easy diseqc configuration setup will be useful in core VDR (+1).
The reelbox had such a feature in the past don't know if current versions do.
Regards halim
-
Halim Sahin -
martinez＠embl.de -
Morfsta