Hi,
The xmltv2vdr script is not working for me on VDR 1.7.16. There is no EPG on the target channels. Anybody can confirm if it is working for you or not. Thanks a lot.
BTW, I know I should run the scrip with the -p parameter as SDVRP port in VDR has changed, but the script runs without error and no EPG is shown.
Best Regards
Sami
Works fine for me on vdr-1.7.16
----- Original Message ----- From: "semsem85 sami" sami8519@hotmail.com To: vdr@linuxtv.org Sent: Monday, November 01, 2010 3:44 AM Subject: [vdr] xmltv2vdr does not with VDR 1.7.16??
Hi,
The xmltv2vdr script is not working for me on VDR 1.7.16. There is no EPG on the target channels. Anybody can confirm if it is working for you or not. Thanks a lot.
BTW, I know I should run the scrip with the -p parameter as SDVRP port in VDR has changed, but the script runs without error and no EPG is shown.
Best Regards
Sami
vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
Suggest you run it against a cut down channels.conf (with maybe just one channel) and with the -s switch to simulate output.
Have a look at the EPG commands created and see if they work manually (telnet 127.0.0.1 6419)
Works fine for me on vdr-1.7.16
----- Original Message ----- From: "semsem85 sami" sami8519@hotmail.com To: vdr@linuxtv.org Sent: Monday, November 01, 2010 3:44 AM Subject: [vdr] xmltv2vdr does not with VDR 1.7.16??
Hi,
The xmltv2vdr script is not working for me on VDR 1.7.16. There is no EPG on the target channels. Anybody can confirm if it is working for you or not. Thanks a lot.
BTW, I know I should run the scrip with the -p parameter as SDVRP port in VDR has changed, but the script runs without error and no EPG is shown.
Best Regards
Sami
vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
Your channel lines may have changed, even if it was only one character. Get a new copy and test a single line again. I had to do the same last night, because of the channel names updating... Theunis
On 31 October 2010 16:44, semsem85 sami sami8519@hotmail.com wrote:
Hi,
The xmltv2vdr script is not working for me on VDR 1.7.16. There is no EPG on the target channels. Anybody can confirm if it is working for you or not. Thanks a lot.
BTW, I know I should run the scrip with the -p parameter as SDVRP port in VDR has changed, but the script runs without error and no EPG is shown.
Best Regards
Sami
vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
-
semsem85 sami -
Simon Baxter -
Theunis Potgieter