This mornig I found strange behaviour: VDR claimed to show & record Channel 4, but program was from Ch 1. And recording from yesterday was also similar way.
I tested bit more, and found out that if I first tune to Ch 3, which is on same transponder as 4, I can get Ch4 working. But if I have tuned to Ch1 or Ch2, after it change to Ch4 shows picture of Ch1, but claims to be on Ch4.
Ch1: YLE TV1;YLE:578000:I0C12D0M64B8T8G16Y0:T:27500:512+128:650=fin:2321:0:17:8438:4097:0
Ch4: Nelonen;Ruutunelonen Oy:490000:I0C12D0M64B8T8G16Y1:T:27500:512:650=fin:576:0:65:8438:8193:0
Channels have same pids, and apparently vdr commands tuning to another transponder, but it's not done, and vdr gets legal pid values from wrong transponder.
My setups is: Technisat Airstar2 Nova-T TEchnotrend DVB-S 1.3 as output.
My DVB-T signals is weak, but looks clean with Airstart (No bit errors). Tuning from 4 to 1 works perfectly, no confusion there.
Apparently I could avoid problem saying '1+2 with card 1, 3+4 (possibly all other channels on same transponder) with card 0' or something similar. Is there some way to do it?
On Tuesday 03 May 2005 10:42, Markku Tavasti wrote:
Apparently I could avoid problem saying '1+2 with card 1, 3+4 (possibly all other channels on same transponder) with card 0' or something similar. Is there some way to do it?
Yes you can!
All you have to do is to edit the channels.conf file's 9th field. This is the number of the dvb device used to decode the channel. Devices defined in ca.conf.
Jukka Tastula jukka.tastula@kotinet.com writes:
Apparently I could avoid problem saying '1+2 with card 1, 3+4 (possibly all other channels on same transponder) with card 0' or something similar. Is there some way to do it?
All you have to do is to edit the channels.conf file's 9th field. This is the number of the dvb device used to decode the channel. Devices defined in ca.conf.
Yes, it fixes the problem. Thanks!
However, if someone tries to fix the problem in code I can test fixes.
-
Jukka Tastula -
Markku Tavasti