1 Jan
2006
1 Jan
'06
9:35 p.m.
I am using vdr 1.3.37 on full featured thechnisat Rev 1.3 card. Drivers are from kernel 2.6.14. I have another digital receiver connected on the loop output of the ss1 board. After closing vdr by ctrl-c in console the ss1 in not powering anymore the LNB leaving the other receiver to do that but is not allowing the high frequency signal to pass trough (I presume ) since the other receiver is indicating bad signal. If I restart the computer all is ok until I start again vdr. I don't know if the problem is from vdr or drivers.